Distortion rate

GOMono-F5 receiver 16 UHF frequenciess Frequency range: UHF 514~542 MHz (4G compatible) The Diversity system ensures a perfect reception Adjustable Squelch to absorb interferences You can use up to 4 receivers at the same time (4 mic) Adjustable antennas (front) Average range in perfect conditions: 70m Outputs: balanced XLR3-M and 6.35 mm TS-F unbalanced jack Use FREE-RACK to stack them in racks (optional) Dimensions: 130 x 36 x 92 mm GOHand-F5 transmitter Handheld microphone only Must be combined with a GO-MONO receiver High-quality unidirectional electret Distortion rate: less than 1% at 1 kHz OperatesWith 2 1.5V type LR6/AA batteries Dimensions: Ø 58 mm x 237 mm

GO Hand transmitter Handheld microphone Must be combined with a GO Mono receiver High-quality unidirectional electret capsule Distortion rate: less than 1% at 1 kHz Operates with 2 x 1.5 V type AA batteries Dimensions: Ø 237 mm x 58 mm GO Mono receiver 16 UHF frequencies UHF Frequency range: 823 ~ 832 and 863 ~ 865 MHz (4G compatible) The diversity system ensures a perfect reception Adjustable squelch to absorb interferences You can use up to 4 receivers at the same time (4 mics) Adjustable antennas (front) Average range in perfect conditions: 70 m Outputs: balanced XLR3-M and unbalanced 6.35 mm jack Use FREE-RACK to stack them in racks (optional) Dimensions: 130 x 36 x 92 mm

Ciao. Ti propongo un magnifico strumento della dea Musica: un compressore, espansore di dinamica (PERFETTO) della Threshold. The DBX 119 was developed for audiophiles and professional sound engineers who need a greater compression range and the capability of expanding or compressing above a pre-set threshold. The DBX 119 can re-expand the limited dynamics of tapes, records and FM broadcasts and bring your music back towards it is original dynamics. The 119 is easily connected to your receiver or integrated amplifier/preampliifer. Specifications; Compression & expansion: continuous from 1.4 compression slope (14 dB output change/20 dB input change) to 2.0 expansion slope (20 dB output change/10 dB input change) - Dynamic range: 120dB input or output - Input noise: -110 dBm typical, -100 dBm maximum - Input level: maximum input signal in excess of 30 Volts RMS - Input impedance: 50K ohms - Output level: maximum output 10 Volts RMS open circuit; +17 dBm into 600 ohms - Output impedance: 500 ohms - Distortion: 0.5% maximum 20 Hz, 0.2% typical above 50 Hz for complete cycle of compression and expansion; 1.2% 20 Hz for 2:1 expansion;.05% typical 1 KHz and above for any setting of controls (3 Volts RMS or less input or output.) - Frequency response: +0, -1dB 20 Hz to 20 KHz - Attack time: 50 dB/m Sec maximum initial attack rate 1.4 expansion. 12 mSec to 65% of final value any setting of compression or expansion. Adjusted to be within integrating time of human ear within the constraints of reasonable low frequency distortion. - Release (decay) time: constant rate 140 dB/sec (norm) or 50 dB/sec (slow) 1.4 expansion - Level match control: unity gain point may be varied from 100 mV to 1 Volt - Power consumption: 115 VAC 50-60 Hz 2 Watts - Dimensions: 3 3/4 x 5 1/4 x 9 inches - Weight: 4.5 lbs. Provvisto di manuale, spedisco con corriere a costi modici. Grazie per l attenzione, buona vita a te. Andrea

Vendo soundstream tatrantula tr 880.2 vero made in usa Soundstream Tarantula Chrome 880/2 Lowpass-Filter / Alipäästö: 30 - 4000 Hz Highpass-Filter / Ylipäästö: 30 - 4000 Hz Subsonic- Filter: 10 - 100 Hz Q - Bass - Boost: 30 / 36 / 44 / 60 Hz Power Bandwidth: 10 Hz - 50 kHz Total Harmonic Distortion: 115 dB Input Topology: Instrumentation Input Sensitivity: 150 mv - 12 Volt RMS Input Impedance: 10 k Ohms Load Impedance (Stereo) 2 - 8 Ohms Load Impedance (Bridged) 4 - 8 Ohms Supply Voltage: 11 - 15 Volts Damping Factor / Vaimennuskerroin: > 500 Slew Rate: >50 V/µS QBASS™: Up to + 12 dB Boost @ 40 Hz, Up to + 18 dB Boost Crossovers: 12 dB / Octave Crossovers Frequency: 30 - 4 kHz Tehonanto RMS: 2 x 220 Watts @ 4 Ohm Tehonanto RMS: 2 x 440 Watts @ 2 Ohm Tehonanto RMS: 1 x 880 Watts @ 4 Ohmiin Sillattuna / Bridged Mitat: L x K x P (312 x 102 x 500mm) gli amplificatori sono ancora installati e perfettamente funzionanti disponibili per qualsiasi prova, li vendo a 350 euro a pezzo

RCF ED600 finale amplificatore di potenza, utilizzato solo e sempre in ambito hifi, ingressi bilanciati, ibrido mosfet/transistor, alta dinamica,suono cristallino, utilizzato sempre con JBL xpl200, vendo x upgrade Power output stereo 4?:2 x 300 W rms Power output stereo 8?:2 x 180 W rms Power output bridged 8?:600 W rms Frequency Response -3 dB:20 Hz ÷ 20 kHz Signal/noise rate:> 105 dB Crosstalk:> 70 dB Distortion (THD+N):

Ottimo finale ibrido di Audio Research, potente e veloce, l'HD220 non teme alcun diffusore. Ottime condizioni, senza imballo originale. Power output 220 watts per channel into 8 ohms from 20Hz to 20kHz. 380 watts per channel into 4 ohms. Power bandwidth Frequency response (-3dB points at 1 watt) 0.5Hz to 200 kHz Input sensitivity 4.0V RMS BAL for rated output. (20.8 dB Bal gain into 8 ohms.) Input impedance 300K ohms Balanced, 150k ohms SE Output taps Output regulation Approximately 0.07dB 8 ohm load to open circuit Overall negative feedback None Damping factor Approximately 130 Distortion Slew rate Rise time Hum & noise Less than 0.1mV RMS -112dB below rated output (IHF weighted, input shorted). Power supply energy storage 200,000 µF Power requirements 105-125VAC 60Hz (210-250VAC 50 Hz) 750 watts at rated output (220 WPC 8 ohms) 1200 watts max (380 WPC 4 ohms) 250 watts at "idle." Tube complement (2) 6H30 driver, (2) 6922 voltage amp. Other Output polarity: Non-inverting. Balanced input pin 2+ (IEC-268). Dimensions 19" (48.3 cm) W x 8.75"(22.2 cm) H x 19.5"(49.5 cm) D. Handles extend 1.5" (3.8 cm) forward. Weight 58.9 lbs. (26.8 kg) Net; 73.8 lbs. (33.6 kg) Shipping

Amplificatore integrato stereo Bluenote Demidoff Villa in ottime condizioni estetiche e funzionali. Caratteristiche tecniche: FREQUENCY RESPONSE: 10Hz – 20KHz +/- 3dB. THD (Total Harmonic Distortion): 0,05% 20Hz - 20KHz. INPUT IMPEDENCE: 47 Kohm. INPUT SENSIVITY: 550mV. RATIO SIGNAL/NOISE: -98dB W. -92dB L. SLOW RATE: 13Volt. POWER OUTPUT: 50w per Channel. POWER CONSUMPTION: 4ohm: 420watt MAX - 8ohm: 290watt MAX. DIMENSIONS: 430mm L x 220mm H x 450mm D. WEIGHT: Kg. 15,00. Made in Italy. Telecomando, manuale ed imballo originale inclusi. Eventuale presa visione, prova e ritiro presso la mia abitazione.

Marchio: Morley Categoria: Multieffetto per chitarra Multieffetto completamente analogico con Wah, Distorsione a 2 canali, Chorus ed Echo stereo Circuito rieditato di effetti Morley d'epoca: Wah del 2000, Distorsione del 1990, Chorus del 1980 ed Echo del 1970 Finitura in acciaio inox che rende omaggio alla famosa finitura cromata Morley degli anni '70 Attivazione del Wah switchless: basta premere per attivarlo e rilasciarlo per escluderlo Circuto Wah ottico che non si usura mai Distorsione con controllo di alti, medi e bassi Controllo del Gain pre e post e opzione Hi Gain commutabile Il Chorus è dotato di controllo di Rate e Depth L'Echo ha i controlli Delay Time, Repeat e Mix L'FX loop è posizionato tra i circuiti Distortion e Chorus Circuito Buffer premium che impedisce la perdita di segnale e mantiene il suono Alimentato da un alimentatore One Spot 9V incluso Dimensioni: 305 x 174 x 70mm Peso: 2,27kg

Marchio: Rondson Categoria: Microfoni Senza Filo Palmari Four Channel Wireless Handheld Microphone System; PLL synthesizer; UHF Frequency Range: 669.1/655.0/676.6/663.0 MHz easy-to-read LCD displays; 50 mt. in open areas; Modulation Type: FM; Frequency Deviation: +/- 22 kHz; Frequency Response: 50-15.000 Hz; Frequency Stability: +/- 10 ppm; Interference Rate: b'>' 50dB; S/N Ratio: b'>' 90dB; Sensitivity: - 80 dBuV; Distortion: b' Output Impedance: 600 ohm; Audio Output Level: - 400 mV (balanced/unbalanced); Output connectors: 4x XLR-3M, 1x Jack TRS 6,3mm; Antenna connectors: 2x BNC; Receiver BE-1040: dimensions: 480x180x46 mm, weight: 3,5 kg, power: 110-240V / 12 V 1000 m A, consumption: b' Transmitters BE-1040MIC: dimensions: 240x50x33mm, RF Power: 10 mW, power supply: 2x 1,5V AA.

Marchio: Audiophony Categoria: Finali di potenza Class-D amplifier Switched-mode power supply Mode selection: Stereo, Bridge or Parallel Independent limiter for each channel Extremely accurate and independent level settings for each channel LEDs indicators Convection cooled Balanced Jack TRS and XLR inputs Unbalanced RCA outputs Binding post-jacks or speakON outputs Short-circuit, over current and high temperature independent protections for each channel 2x19" rack mount spaces Stereo Max power: 4 Ω RMS stereo power (minimum): 2 x 150 W RMS; 8 Ω RMS stereo power: 2 x 80 W RMS Mono bridged Max power: 8 Ω bridged power (minimum): 1 x 300 W RMS Signal-to-noise ratio Less than 90 dB Input sensitivity: 4 dBu +/-2 dB Distortion: THD at 1 kHz 1/2 rated power Less than 0.1%; Slew rate: - 65 dB at 1 kHz; Frequency response (4 Ω/1 W): +0.5 dB; 20 Hz-20 kHz Input impedance: unbalanced 15 kΩ / Balance 30 kΩ Clip: 0 dBr Cooling: Convection cooled Input connectors: XLR3-F, Balanced 6.35 mm TRS-F jack + Unbalanced RCA Output connectors: Binding post-jacks + 4-pole speakON® Front control panel: AC power switch, Channel 1 and 2Volume Rear control panel: Mode selection button Indicators: Protect (red) / Clip (yellow) / Signal (green) Protections: Short-circuits, over current and high temperature protected Power supply: 100/230 V AC - 50/60 Hz Dimensions: 482 mm x 44 mm x 330 mm NetWeight: 4.3 kg